Page protocole

Step 1 - Preparation of the nail
Degrease the nail with Green Flash Solvent Water.

Step 2 - The basis
Apply the Green Flash Base Coat in thin layers. It is not necessary to put too much. Then, border the nail by passing over the edge.
This step is very important. It prevents peeling and better adhesion of the color.
Once the base is laid, catalyze under pro Green Flash lamp for 1 minute.

Step 3 - The color
Then apply your favorite Green Flash color in 2-3 brush strokes. To do this, start from the middle, then make each side of the nail.
Once again, it is important to take the minimum amount of material. Border, then catalyze under pro Green Flash lamp 1 minute.
Repeat the step to obtain 2 thin layers of color.

Step 4 - The top
Apply the Green Flash Top Coat, border and catalyze under pro Green Flash lamp for 2 minutes.

TIPS - Apply green oil
Once the Green Flash manicure is finished, use the Green Oil to beautify and moisturize the skin.
Take a few drops, apply to the cuticles and massage to moisturize. It is possible to go up to the level of the fingers.

And that's it, your GF Manicure is done, enjoy a shine and hold for up to 10 days!

Step 1 - Prepare for removal
Cut 10 pieces of cotton wool suitable for the size of the nails.

Step 2 - Apply the soaked cotton pads to each nail
Apply to each nail a cotton pad soaked in mild remover, or a papillote.
Let the cotton pads sit for a minute.

Step 3 - Remove the Green Flash
Rub lightly and gently pull towards the outside of the nail to prevent residues from getting into the cuticles.

TIPS 1 - Remove the base residues
If there are any base residues left, rub again with a cotton pad soaked in solvent.

TIPS 2 - Apply Green Oil
To moisturize the nail contour, finish the Green flash removal by applying the green oil.

And now the drop-off is over, you are ready for a new color!